Wedge spreaders (pineapple tenor)
Bars that press the sides home against the mold walls while the blocks and linings go in — the same bars hold the rim's shape when it comes out of the mold. No turnbuckles: one wedge and a wedge-shaped foot do the spreading. Build them before Session 5, with the body mold.
Plan view, neck at the top. Two spreaders: upper and lower. Each bar is on the left; the green block at the right end is the wedge + foot-wedge.
How it works
The bar spans the rim's inner width with a cork pad on its fixed end. At the other end, the wedge sits against the bar and the foot-wedge against the side, cork face out. The two are mirror tapers (1:8) — together a rectangle that gets thicker as the wedge is tapped down, spreading bar and foot apart. The 1:8 taper is self-locking, so the wedge stays put when you let go. To release, pull the wedge up by its heel — it stands proud of the rim.
Dimensions
- Upper — body 7.53 in, inner 7.19 in, bar 6-5/16 in.
- Lower — body 8.94 in, inner 8.60 in, bar 7-3/4 in.
- Bar — hardwood, 3/4 × 1-1/2 in section. Rule: cut the bar 7/8 in shorter than the inner width you measure (5/8 in wedge pair + 1/4 in slack for easy placement).
- Wedge & foot-wedge — hardwood, 3 in long × 3/4 in wide, tapering 1/2 in → 1/8 in (1:8). Cut both from one setup so the tapers match, then flip one over.
Three pieces of wood and two cork pads per spreader. Measure your rim — bent sides vary, so the table is the nominal starting point from the template outline, and the wedge takes up the difference.
Downloads
The drawing has the plan, the wedge mechanism detail, the dimensions table, and the parts list.