Pineapple Tenor Ukulele — Beginner Build Class

session handouts

Session handouts

One-page guides for each class meeting, plus the detailed Session 1 guides (brace stock and bridge) and the build spec sheet — the operations, key dimensions, checkpoints, and the permanent record that follows each ukulele. Print the current one before class, or pull it up on your phone at the bench.

  1. Session 1 — Kickoff: brace stock + bridge Make the top brace set and the bridge — the build's two "bookends." Two operation handouts: brace stock (dimensions and planing) and bridge (jig workflow and shaping), plus a dimension drawing of the finished bridge and the build spec sheet that follows the ukulele through the whole build. The jigs used today — the brace-planing jig and the 3D-printed bridge jigs — live on the Jigs page.
    Brace stock PDF Bridge PDF Bridge drawing PDF Build spec sheet PDF
  2. Session 2 — Join + thickness plates Join the top and back plates and thickness them to final dimension.
    Plates PDF
  3. Session 3 — Brace the top Lay out the top bracing pattern and glue the top braces in the go-bar deck, or with clamps and cauls when the deck is busy.
    Session 3 one-pager Detailed top-bracing guide Alternative glue-up (clamps + cauls)
  4. Session 4 — Brace the back Glue the back braces in the go-bar deck. Homework before Session 5: build the body mold and the wedge spreaders — see the Jigs page. You will need them for bending and lining.
    Back bracing PDF
  5. Session 5 — Bend sides Bend the sides to shape — pick your method. Two handouts: bending-iron and side-bending jig.
    Iron method PDF Jig method PDF
  6. Session 6 — Blocks, linings, rim Fit the head and tail blocks, install the linings, and true up the rim.
    Rim PDF
  7. Session 7 — Close the body Close the body: glue the back and top to the rim, then trim the overhang.
    Close the body PDF
  8. Session 8 — Fit neck + fretboard Clean up the body and fit the supplied neck and fretboard with the dowel joint.
    Neck fit PDF
  9. Session 9 — Finish Sand, mask the fretboard and bridge areas, and apply the finish.
    Finish PDF
  10. Session 10 — Bridge install + setup Glue the bridge and neck, let everything cure, then final setup to a playable instrument.
    Bridge + setup PDF